What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 05:08
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
But… the neutral is now “floating” because of the 1 ohm resistance.
Edit 2024–10.
Is it true that some Trump voters are saying its good that the stock market is collapsing?
[old diagram got deleted by accident]
An AC voltage/ current source, and an ac inductive load.
I post the exact comment here.
What is the lowest probability event you have personally witnessed?
One is “what exactly is in a ‘surge protector’ ? ”
He then asserts :
One
How to watch George Clooney in ‘Good Night, and Good Luck’ live for free - New York Post
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is where this question deviates from being a 'generic' question, and becomes more specific.
What is the most memorable thing that happened in your college days?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What does a fuse do?
the problem then depends on "how fast does the fuse operate?".
This is 'the assistant's answer'
At least they know the answer if they wanted it.
First Sentence:
It seems Mohan does not understand the difference between a comment and an Answer.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Craig Breslow Discusses Red Sox’ Struggles, Future Plans - MLB Trade Rumors
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
nine
a photo is worth a thousand words.
Screen Time Nightmare: How ‘Digital Pacifiers’ Are Sucking The Sanity Out Of Children - Study Finds
What is lightning?
There are three different concepts here that are getting confused.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There are two important concepts here.
eight
2024–10–16 [ OO OLAOYE OYEBODE ]
A circuit breaker is similar, but is resettable.
But it can get overloaded, and no longer works.
so, what happens?
David Hogg to depart as DNC vice chair after months of turmoil - The Washington Post
but I think this circuit , shows a few more pieces.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Whooping cough cases rise sharply in Washington and Oregon, health officials urge vaccination - KGW
This is the picture of an electronic coil of wire wound around a core of magnetic material.
A fuse is a non-resetable over current circuit protector.
These are simplified answers to the original question, and does not change anything I wrote above.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
These devices are installed between the “hot” and “neutral” and protective ground.
Teddi Mellencamp cozies up to rumored new boyfriend during romantic outing - Page Six
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–10[John johnson John Johnson ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
He then describes Rainy Season and Lightning.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So, the voltage could go up to 500 volts, and the fuse will not open up.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The third is lightning and “how it gets conducted into a home.”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
Upvotes:
This device then solves the entire problem.
[image of Common-mode choke]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
what exactly is a ‘surge’ protector?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
(Dc diagram shown, AC is similar).
The bolt then partially travels down the line to your home.
Now when you have a certain ac resistance, then a current flows in a loop.
but this device (an Inductor) … impedes the rapid changes in the current.
Here is a simplified AC power diagram.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The MOV will conduct when the voltage exceeds 50% of line voltage.
In schematic diagrams this is the symbol for a fuse:
The other is “what does a “fuse” do?”
He then describes the function of a fuse.
It also is a device that limits the change in current flow.
This one hit behind the barn.
For this case there are devices called Metal oxide varistors (MOV).
At one ohm, the resistor has a maximum of 1 watt power.